fbpx
Sale!

3D Printer kit 1pcs Mega 2560 R3 + 1pcs RAMPS 1.4 Controller+ 5pcs DRV8825 Stepper Motor Drive + 1pcs LCD 12864 controller

$68.02 $61.90

9953 in stock

SKU: 32581848593 Category:

Description

start

Brief introduction

The DRV8825 stepper motor driver carrier board TI DRV8825 micro bipolar stepper motor drive is a breakthrough. The module has a pinout and interfaces with our A4988 stepper motor driver carrier is almost the same, so it can be used as a better performance of the pull-down menu board replacement in many applications. DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step). It uses 8.2 – 45 V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).
Product Features
A simple steps and direction control interface
2 six different steps resolutions: full-step, half step, 1/4-step1/8-step1/16-step, 1/32-step
3.CAN interface directly with 3.3 V and 5 V systems
4 Over-temperature thermal shutdown, overcurrent shutdown, Undervoltage lockout
5 short to ground short circuit load protection
6.4 Layer 2 oz copper PCB, in order to improve heat dissipation
7 exposed solder ground below the bottom of the driver IC on the printed circuit board pad
8 module size, pin and interface matching A4988 stepper motor driver operators in many ways
9 adjustable current control lets you set a potentiometer, which lets you use the stepper motor’s rated voltage or more, in order to achieve a higher rate of maximum output current step
10 Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
11 Maximum 45 V supply voltage
12 built-in voltage regulator (the need for any external logic supply voltage)
Package Included:
1 X mega 2560 R3
1 X Ramps 1.4
1 X usb line
5 X DRV8825 module with heatsink
1 X LCD 12864 controller
1 X adapter
2 X cable


Additional information

Brand Name

EQV

Condition

New

Type

Voltage Regulator

Reviews

There are no reviews yet.

Be the first to review “3D Printer kit 1pcs Mega 2560 R3 + 1pcs RAMPS 1.4 Controller+ 5pcs DRV8825 Stepper Motor Drive + 1pcs LCD 12864 controller”